Efficient peeling cuts revisited

Here's another example of how to arrange peeling cuts for efficient cleaning of an SD300 model. The user adds peeling cuts (the purple walls) while preparing to build models in the SDView software. Peeling cuts don't affect the model, but they instruct the SD300 to cut the support material that surrounds the model so it can be torn away conveniently.

When I had just learned to use the SD300 I tended to put peeling cuts between each individual model to isolate them, resulting in lots of small areas that had to be cleaned one-by-one. But I eventually learned to arrange models so the peeling cuts could be joined and streamlined, peeling several models at once.


These nine models have two continuous peeling cuts that follow the geometry, so the two exterior regions can be peeled away in an easy continuous motion.


After the two outer strips have been removed the models are still connected by leftover support material between them. Much of this can be peeled away in the same manner, as the top and bottom areas are continuous just like the other strips were.


There's still some support material embedded in the middle layers between models, but it doesn't have to be removed layer-by-layer like the other strips. Instead I just loosened up the support material by squeezing a probe between layers in several places...


...then I gripped two adjacent models and gently twisted them to-and-fro, which gradually loosened the support material between the two adjacent pieces. In about 10 to 15 seconds the leftover material was loose enough to free the two adjacent pieces, and I moved on to the next pair of embedded models.


All told, it took less than ten minutes to completely clean these models. The same batch of models probably would've taken a half hour or more if I had isolated them with individual peeling cuts. Back when I was just learning to peel and clean models it probably would've taken over an hour, so experience helps too!